M 36

It is the shock setting mortar that is ready to use, instantly freezing water. When it comes into contact with water, it blocks water by setting in 40 seconds.

Information

Water Plug, Rapid Setting Mortar to Plug Active Water Leaks

It is the shock setting mortar that is ready to use, instantly freezing water. When it comes into contact with water, it blocks water by setting in 40 seconds. ISONEM M 36 is used in drying active water streams and for surface water. ISONEM M 36 is for preparation for insulation by stopping water. It has high expansion property, does not shrink. It does not contain soda or chlorine, it does not harm the reinforcement and iron, the adherence property is excellent.

TECHNICAL SPECIFICATIONS

· Type : Cement based

· Class of fire reaction: CLASS A2

DOCUMENTS OF THE PRODUCT

CE Certificate
ISO Certificate

SDS (EN) – ISONEM M 36

Usage Areas

· Stopping pressurized water,

· To stop water leaks before cement-based insulation is applied,

· In drying the surface and in the prevention of races coming from cracks,

Application Type

Application Method: The application is made in powder form. Rubber gloves should be worn during application. To the prepared surface, a small amount of dust is taken into the palm for the buffer and the material is hand-pressed by hand to the area of the active water leakage. This process is continued until the powder hardens and water is cut off. After the water is stopped, the free material remaining on ISONEM M36 is cleaned with a dry brush. Then, ISONEM M 35 is applied in three layers to form permanent insulation. If ISONEM M 36 is applied as a mortar, it is mixed with clean water in 2/5 ratio (40%) and put into a paste consistency. This mixture is prepared kneadable without crumbling. This mortar starts to heat up with the reaction and the mortar that is heated is turned into a plug pressed into the hole where the water is released. It is expected to be fully hardened and the hand is held there for a while. As in the dry application, the ISONEM M35 is applied in three layers and the insulation is completed.